Recent content by Projectrs200

Twingo Forum

Help Support Twingo Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. P

    RS monitor subsequently installed!

    So this shows why you need a Bluetooth...as the wiring harnesses are different. My plan is to get a wiring harness and swap whole thing over. Means pulling up carpets and full dash out...but hey. Real question is...when I get clip to reprogramme...how do I access a menu to also switch on the...
  2. P

    RS monitor subsequently installed!

    Resurrecting an old thread I know...but I am installing RS monitor to a 2008 RS... it didn't have a screen as standard...but I will make it work.
  3. P

    Replace heater control lights?

    T5. Need to remove vents on dash and get at it behind. Only a few torx screws to get the speedo out. Need to remove passenger airbag which needs a 13mm deep socket which can be a pain though.
  4. P

    New to the forum, 2nd hand 2010 RS

    Hi. All different wiring is needed. Radio harness, climate harness, temperature harness. Alot of effort. I have all the parts and still unable to do it! The display doesn't show much information, the Renaultsport Monitor is another add on which shows 0-60 times etc. The normal display is just...
  5. P

    HOW TO: Retro fit Cruise control

    No, both twingo 2, one my original, one a new one with cruise control. Going to fit my mk2 wheel with cruise this weekend, make sure that works, then send off the mk3 circuit boards to a phone repair who can do the smd soldering. If it all works, I'll have a spare squib I can try altering.
  6. P

    HOW TO: Retro fit Cruise control

    Is it possible to add into the squib? There clearly space for 4 connections in there, or maybe modifying another squib that already has 4 in use?
  7. P

    HOW TO: Retro fit Cruise control

    Great. Got confused by the phone wires. How about getting the horn to work then...?
  8. P

    HOW TO: Retro fit Cruise control

    @Chester amazing. The exact thing I am after, and you have explained it like a champ. Once I get the resistor values, how would I connect that to the mk2 cruise squib, that only has two wires?! Much appreciated!
Top