Good evening all,
Quick bit of advice required.
I need to replace front passenger side brake pipe (corroded)
It’s a short run straight from flexy hose to ABS unit
But... assuming some air will enter the ABS valve block.
Is there a risk of air getting trapped inside (ABS)?
Will conventional bleeding remove it. Or will I need to cycle ABS via diagnostics? Not something I can do at home without full dealer software.
Quick bit of advice required.
I need to replace front passenger side brake pipe (corroded)
It’s a short run straight from flexy hose to ABS unit
But... assuming some air will enter the ABS valve block.
Is there a risk of air getting trapped inside (ABS)?
Will conventional bleeding remove it. Or will I need to cycle ABS via diagnostics? Not something I can do at home without full dealer software.