Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Twingo Technical & Detailing Information
Suspension & Brakes
Brake lights switch - help please
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Twingo Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="EpsomJames" data-source="post: 180186" data-attributes="member: 3877"><p>I have these instructions provided by Oscar (sadly the hosted photos that came with them have gone)</p><p></p><p>1. hold your pedal down.</p><p></p><p>2. Then with your other hand, twist the switch off (counter clockwise) to remove it from the hole</p><p></p><p>3. Then if you grab the switch plunger on the end and push the plunger itself, it will click, let go and push again.. it will click again. Inside it alters a plastic shaft type ratchet system, to reset it, pull the plunger out and it will click out altogether.</p><p></p><p>After every setting, place the switch back in the hole (holding pedal down when you do so it will sit properly) and test your switch by tapping your pedal with your hand and looking to the back of your car at the lamps.</p><p></p><p>If it's not working straight away repeat step 3.</p><p></p><p>The panel in front of the pedal pops off for easier access.</p></blockquote><p></p>
[QUOTE="EpsomJames, post: 180186, member: 3877"] I have these instructions provided by Oscar (sadly the hosted photos that came with them have gone) 1. hold your pedal down. 2. Then with your other hand, twist the switch off (counter clockwise) to remove it from the hole 3. Then if you grab the switch plunger on the end and push the plunger itself, it will click, let go and push again.. it will click again. Inside it alters a plastic shaft type ratchet system, to reset it, pull the plunger out and it will click out altogether. After every setting, place the switch back in the hole (holding pedal down when you do so it will sit properly) and test your switch by tapping your pedal with your hand and looking to the back of your car at the lamps. If it's not working straight away repeat step 3. The panel in front of the pedal pops off for easier access. [/QUOTE]
Insert quotes…
Verification
Post reply
Twingo Technical & Detailing Information
Suspension & Brakes
Brake lights switch - help please
Top