broomie699
Active member
- Joined
- May 1, 2017
- Messages
- 35
- Reaction score
- 0
Hi, I'm planning on moving my battery to the boot of my twingo gt.
I've done a bit of research as not to fantastic with wires.
I have purchased so far
4m of 16mm 110amp red cable
1m of 16mm 110amp black cable.
Fabricated own tray.
I've heard things about having circuit breaker (fuse) in case the wires touch metal. Has anyone else done this and what circuit breaker do I need I presume one for 110amp?
I'm a little stuck on relocating to. I have 2 red cables joining the battery attached to a plate. One is for the starter motor and other is just general wire. Would I be able to buy a 2 in 1 out terminal for this???? Please let me know if you know what other bits I need
Regards George
I've done a bit of research as not to fantastic with wires.
I have purchased so far
4m of 16mm 110amp red cable
1m of 16mm 110amp black cable.
Fabricated own tray.
I've heard things about having circuit breaker (fuse) in case the wires touch metal. Has anyone else done this and what circuit breaker do I need I presume one for 110amp?
I'm a little stuck on relocating to. I have 2 red cables joining the battery attached to a plate. One is for the starter motor and other is just general wire. Would I be able to buy a 2 in 1 out terminal for this???? Please let me know if you know what other bits I need
Regards George