Forums
New posts
Search forums
What's new
New posts
Latest activity
Members
Registered members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Twingo Technical & Detailing Information
Engine, Gearbox, Exhaust, Intake
Tailpipes
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Twingo Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="madmatt" data-source="post: 10167" data-attributes="member: 93"><p>Right, I figured I should just update this instead of cluttering the forum with another thread about an exhaust =P</p><p></p><p>So....</p><p></p><p>Can anyone tell me the bend angles of the exhaust upto the over axle bend of the back box?</p><p></p><p>I thought it was a 100mm Flexy into a 30 then a 60 degree bend before the first box. From the joint to the 60 degree bend was approx 400mm (taking out the first box).</p><p>Then from joint to the bend before the over axle bend was about 850mm then into a 30 degree bend?</p><p></p><p>Just asking if someone with a bit of past experience of the exhaust or better access to a garage with axle stands etc could check for me?</p><p></p><p>It would be appreciated</p><p></p><p>M</p></blockquote><p></p>
[QUOTE="madmatt, post: 10167, member: 93"] Right, I figured I should just update this instead of cluttering the forum with another thread about an exhaust =P So.... Can anyone tell me the bend angles of the exhaust upto the over axle bend of the back box? I thought it was a 100mm Flexy into a 30 then a 60 degree bend before the first box. From the joint to the 60 degree bend was approx 400mm (taking out the first box). Then from joint to the bend before the over axle bend was about 850mm then into a 30 degree bend? Just asking if someone with a bit of past experience of the exhaust or better access to a garage with axle stands etc could check for me? It would be appreciated M [/QUOTE]
Insert quotes…
Verification
Post reply
Twingo Technical & Detailing Information
Engine, Gearbox, Exhaust, Intake
Tailpipes
Top