Search results

Hi no it seems to stay the same tho noise goes when the clutch is pressed or put on neutral while rolling Thanks for reply

Rattle when in gear while driving bit stops when put into neutral ( sounds like disks but this would happen not just under load)

It's the full ktec system but I heat wrapped the manifold

Yh you don't get a single pop if u change before 4k so not to bad

https://youtu.be/Pq6fUad2-m8

Well first run on the dyno lamba shot clean out the manifold so after rolling it half of the dyno on the floor swapping the lamba sensors over after that everything went ok need to get my graph out and have a read but he managed the pop bang with flames aswel il have to upload the video

What you got on yours so far and isit your first map? Myn myt be worse with it been its first time on the rollers

Yh it can't come quickenuff myns driving worse and worse closer it gets to Tuesday

Did he tell you what time to be there I can't remember If he told me 10am lol

Bumper******

Iv got a decat and a bmc cda intake with bumper mount cold air feed and my flatspot is terrible but I'm in rs tuning on Tuesday :D

What u disappointed with... To loud? Not loudenuff, the tone?

He quoted me 275£+vat booked in on the 6th :D

He quoted me 275£+vat booked in on the 6th :D

Forgot to mention stickers come aswel banged thm on straight away :D

Haha yh they was 4 bolts holding it to the block when I undone the last to it jus fell off I shut my eyes thinking it was goin to land on my face lol. How tight is it tho they could of put the cat under the car somewhere my wrists are bruised from squeezing thm through the tight gaps the loosen...

Manifold changed after a thew hits with a hammer and a thew more swear words lool

Everyones meeting about 8 I think but there's 200+ cars going

Xscape Yorkshire Colorado Way Glasshoughton Castleford WF10 4TA Overflow car park

..............