Maggz for the front badge u just undo the 4 torx bolts and lift the lip up and back then u can get to itmaggi112":1rfwh2ns said:Rear pops out. Just a little fiddly getting leverage.
Front requires the bumper off and to be unclipped from the back. There are several threads with this![]()
Adding that much heat, to fully melt the glue and vinyl, theres a real chance or going a little too far and blistering the laquer... Some heat guns can get to over 200'C which will melt solder, so easily blister paintThursto133":45o23u0s said:Just worth noting guys when removing the sticker. I struggled to remove it and I used a heat gun. My main concern was that I didn't want to lift the paint. However eventually I worked it out so this info will be worth knowing. When removing the sticker heat it evenly and then heat one corner more it should either bubble up or start to bend. Don't worry the paint will not lift. Once the sticker has peeled back from the heat a little get the edge of a credit card or something similar and peel it back enough for a finger hold then just grab and peel it off relatively slowly. Should come off easily if you have applied heat to the entire sticker.
Joey92":3o1yn9gn said:Stupid question, the RS badge on the front, is that just stuck on? I know the back one is
That one IS stuck on with the double sided sticky foamChicken":3lejcu7g said:Joey do you mean this one?![]()
I believe it's just stuck on but I may stand to be corrected.
Yeah, both of them are stuck onJoey92":6zfbjjpj said:Yeah that's the one, and the Renault sports one on the back as well, I did think they were both stuck on
just paint/wrap your current onesJoey92":1hqcgy45 said:I'm attempting to source some white ones to replace them![]()
Joey92":27cicomo said:Yeah that's probably what I'm going to do, although keeping the writing black on the one at the back will be a *****
Enter your email address to join: